[Federal Register Volume 77, Number 182 (Wednesday, September 19, 2012)]
[Proposed Rules]
[Pages 58052-58053]
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
[FR Doc No: 2012-23051]
========================================================================
Proposed Rules
Federal Register
________________________________________________________________________
This section of the FEDERAL REGISTER contains notices to the public of
the proposed issuance of rules and regulations. The purpose of these
notices is to give interested persons an opportunity to participate in
the rule making prior to the adoption of the final rules.
========================================================================
Federal Register / Vol. 77, No. 182 / Wednesday, September 19, 2012 /
Proposed Rules
[[Page 58052]]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2012-1007; Directorate Identifier 2012-CE-031-AD]
RIN 2120-AA64
Airworthiness Directives; GA 8 Airvan (Pty) Ltd Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for GA
8 Airvan (Pty) Ltd Models GA8 and GA8-TC320 airplanes. This proposed AD
results from mandatory continuing airworthiness information (MCAI)
originated by an aviation authority of another country to identify and
correct an unsafe condition on an aviation product. The MCAI describes
the unsafe condition as burnt electrical connectors leading to the
left-hand wingtip pitot heater, which may result in loss of air speed
indication. We are issuing this proposed AD to require actions to
address the unsafe condition on these products.
DATES: We must receive comments on this proposed AD by November 5,
2012.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue SE., Washington, DC 20590, between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact
Gippsland Aeronautics, Attn: Technical Services, P.O. Box 881, Morwell
Victoria 3840, Australia; telephone: + 61 03 5172 1200; fax: +61 03
5172 1201; Internet: http://www.gippsaero.com/customer-support/technical-publications.aspx. You may review copies of the referenced
service information at the FAA, Small Airplane Directorate, 901 Locust,
Kansas City, Missouri 64106.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The AD docket contains this proposed AD, the regulatory
evaluation, any comments received, and other information. The street
address for the Docket Office (telephone (800) 647-5527) is in the
ADDRESSES section. Comments will be available in the AD docket shortly
after receipt.
FOR FURTHER INFORMATION CONTACT: Doug Rudolph, Aerospace Engineer, FAA,
Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri
64106; telephone: (816) 329-4059; fax: (816) 329-4090; email:
doug.rudolph@faa.gov.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or
arguments about this proposed AD. Send your comments to an address
listed under the ADDRESSES section. Include ``Docket No. FAA-2012-1007;
Directorate Identifier 2012-CE-031-AD'' at the beginning of your
comments. We specifically invite comments on the overall regulatory,
economic, environmental, and energy aspects of this proposed AD. We
will consider all comments received by the closing date and may amend
this proposed AD because of those comments.
We will post all comments we receive, without change, to http://regulations.gov, including any personal information you provide. We
will also post a report summarizing each substantive verbal contact we
receive about this proposed AD.
Discussion
The Civil Aviation Safety Authority (CASA), which is the aviation
authority for Australia, has issued AD/GA8/6, dated August 6, 2012
(referred to after this as ``the MCAI''), to correct an unsafe
condition for the specified products. The MCAI states:
CASA has received a number of Service Difficulty Reports
regarding the pitot probe heater connector. The loss of pitot heat
in Instrument Meteorological Condition (IMC) may lead to the loss of
airspeed indication. This may lead to the loss of control of the
aeroplane. Remedial action is to replace the connector with a
terminal block.
You may obtain further information by examining the MCAI in the AD
docket.
Relevant Service Information
GippsAero has issued Mandatory Service Bulletin SB-GA8-2012-77,
Issue 3, dated March 23, 2012. The actions described in this service
information are intended to correct the unsafe condition identified in
the MCAI.
FAA's Determination and Requirements of the Proposed AD
This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to our bilateral agreement with this State of Design Authority, they
have notified us of the unsafe condition described in the MCAI and
service information referenced above. We are proposing this AD because
we evaluated all information and determined the unsafe condition exists
and is likely to exist or develop on other products of the same type
design.
Costs of Compliance
We estimate that this proposed AD will affect 29 products of U.S.
registry. We also estimate that it would take about 4 work-hours per
product to comply with the basic requirements of this proposed AD. The
average labor rate is $85 per work-hour. Required parts would cost
about $100 per product.
Based on these figures, we estimate the cost of the proposed AD on
U.S. operators to be $12,760, or $440 per product.
According to the manufacturer, all of the costs of this proposed AD
may be covered under warranty, thereby
[[Page 58053]]
reducing the cost impact on affected individuals. We do not control
warranty coverage for affected individuals. As a result, we have
included all costs in our cost estimate.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism
implications under Executive Order 13132. This proposed AD would not
have a substantial direct effect on the States, on the relationship
between the national Government and the States, or on the distribution
of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed
regulation:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. The FAA amends Sec. 39.13 by adding the following new AD:
GA 8 Airvan (Pty) Ltd: Docket No. FAA-2012-1007; Directorate
Identifier 2012-CE-031-AD.
(a) Comments Due Date
We must receive comments by November 5, 2012.
(b) Affected ADs
None.
(c) Applicability
This AD applies to GA 8 Airvan (Pty) Ltd Models GA8 and GA8-
TC320 airplanes, all serial numbers, certificated in any category.
(d) Subject
Air Transport Association of America (ATA) Code 30, Ice and Rain
Protection.
(e) Reason
This AD was prompted by burnt electrical connectors leading to
the left-hand wingtip pitot heater, which may result in loss of air
speed indication. We are issuing this proposed AD to modify the
pitot heat wiring on the left-hand wingtip with a terminal block to
prevent loss of heating to the pitot system, which could result in
loss of air speed indication.
(f) Actions and Compliance
Unless already done, within the next 100 hours time-in-service
or at the next annual inspection, whichever occurs later, modify the
pitot heat wiring connector at the left wingtip, following GippsAero
Mandatory Service Bulletin SB-GA8-2012-77, Issue 3, dated March 23,
2012.
(g) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
Standards Office, FAA, has the authority to approve AMOCs for this
AD, if requested using the procedures found in 14 CFR 39.19. Send
information to ATTN: Doug Rudolph, Aerospace Engineer, FAA, Small
Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri
64106; telephone: (816) 329-4059; fax: (816) 329-4090; email:
doug.rudolph@faa.gov. Before using any approved AMOC on any airplane
to which the AMOC applies, notify your appropriate principal
inspector (PI) in the FAA Flight Standards District Office (FSDO),
or lacking a PI, your local FSDO.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in
this AD, a federal agency may not conduct or sponsor, and a person
is not required to respond to, nor shall a person be subject to a
penalty for failure to comply with a collection of information
subject to the requirements of the Paperwork Reduction Act unless
that collection of information displays a current valid OMB Control
Number. The OMB Control Number for this information collection is
2120-0056. Public reporting for this collection of information is
estimated to be approximately 5 minutes per response, including the
time for reviewing instructions, completing and reviewing the
collection of information. All responses to this collection of
information are mandatory. Comments concerning the accuracy of this
burden and suggestions for reducing the burden should be directed to
the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn:
Information Collection Clearance Officer, AES-200.
(h) Related Information
Refer to MCAI Civil Aviation Safety Authority AD/GA8/6, dated
August 6, 2012; and GippsAero Mandatory Service Bulletin SB-GA8-
2012-77, Issue 3, dated March 23, 2012, for related information. For
service information related to this AD, contact Gippsland
Aeronautics, Attn: Technical Services, P.O. Box 881, Morwell
Victoria 3840, Australia; telephone: + 61 03 5172 1200; fax: +61 03
5172 1201; Internet: http://www.gippsaero.com/customer-support/technical-publications.aspx. You may review copies of the referenced
service information at the FAA, Small Airplane Directorate, 901
Locust, Kansas City, Missouri 64106. For information on the
availability of this material at the FAA, call (816) 329-4148.
Issued in Kansas City, Missouri, on September 12, 2012.
Earl Lawrence,
Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. 2012-23051 Filed 9-18-12; 8:45 am]
BILLING CODE 4910-13-P